Latest activity

What's new Featured content New posts Latest activity
  • sam2019
    sam2019 replied to the thread Low End Engine Noise.
    Only 3k miles? has it been sitting a long time without movement in old oil (acid in oil can damage bearings). Any service history...
  • sam2019
    sam2019 replied to the thread Well another happy customer....
    M6 × 0.75 → fine thread, 0.75 mm between threads Thread pitch is a key measurement that describes how "coarse" or "fine" a screw thread...
  • sam2019
    sam2019 reacted to Dool's post in the thread DUM DUM BULLET with Like Like.
    Because the stock muffler is made the way it is, it doesn't take a sniffer tube at the Dyno shop meaning I will not be getting fueling...
  • sam2019
    sam2019 reacted to Mattman's post in the thread J-Engine 500cc Thread with Love Love.
    All of my product arrived today, with no extra charges! Well done I now have plenty of spares for the future in case I decide to open...
  • sam2019
    sam2019 reacted to PieMon's post in the thread ODBII scanning BS4 and BS6 with Like Like.
    Thank you, found it - it was burried deep and not visible from the top by the previous owner or factory. I now ordered cable, Bluetooth...
  • sam2019
    sam2019 replied to the thread Helping the 411 Hima and Scram to brake even :-).
    Even in India the 440 is a rare bird, I will have to do some research if other models use the same caliper as is often the case with...
  • sam2019
    sam2019 replied to the thread Helping the 411 Hima and Scram to brake even :-).
    well, considering I had 5 Himas and all had lousy stock brakes (until I changed them) I think I can judge the improvement with the 440...
  • sam2019
    sam2019 replied to the thread ODBII scanning BS4 and BS6.
    No, the workshop needs the same plug for their diag instrument so all you need to do is visit a RE showroom and ask them to read out...
  • sam2019
    sam2019 replied to the thread Dyno tested..
    going back to car driving :-) ?
  • sam2019
    sam2019 reacted to Dool's post in the thread Dyno tested. with Like Like.
    Tomorrow I return to the Dyno that all my Himalayan runs/Mods/Improvements were done. This time its being done backwards ( again) run...
  • sam2019
    sam2019 reacted to pauli's post in the thread J-Engine 410cc Thread with Like Like.
    Yes, I have the cam lock, crank lock, right cover gasket etc. The bike is partially stripped waiting so the tank, exhaust and coils are...
  • sam2019
    sam2019 replied to the thread ABS Button not working.
    The fact that you got it to work once point at a mechanically defect button I would think. there are YT videos how to take the...
  • sam2019
    sam2019 replied to the thread Head Mods for Combustion Chamber.
    Yeah, I did one from copper too back in the day. But in this case the chain is the issue. so copper likely wont work or any material of...
  • sam2019
    sam2019 replied to the thread The shorty solution.
    Costs more than the bike but hey, if you are height challenged ...
  • sam2019
    sam2019 reacted to murp's post in the thread J-Engine 410cc Thread with Like Like.
    you wont be dissapointed.... my hunter is fabulous now..... 410 big bore plus cam
Show older items
Back
Top